Filter
Top Products
Configuration3-2
From
the main configuration menus below, related configuration parameter values can be dis
Ć
played
and selected.
D
Ribbon Life xxx%
D
Character Set
D
Application Compatibility
D P
aper F
ormat
D
Host Interface
D L
oad P
arameters
D Save Parameters
D Diagnostics
NOTE:
The xxx% in the Ribbon Life menu will not be displayed in the
LCD message if
the
RibbonMinder feature is disabled.
Once
the ENTER switch is unlocked, selected values can be saved as the current configuration
by displaying the value in the LCD and pressing ENTER. You can exit from a configuration
menu
by pressing CLEAR which will place the printer off line.
NOTE:
If an E" is displayed in the upper right corner of the LCD
, the VFU is enabled. If
an L" is displayed in the lower right corner of the LCD
, the VFU is loaded.
Configuration Printout
The configuration printout lists all of the currently selected configuration parameter values.
Figure 3-1 is a sample configuration printout. Configuration parameters on the printout are
listed
in the same order as the configuration menu via control panel.
The following general procedure can be used to obtain a configuration printout. Refer to the
Control Panel Configuration Diagrams beginning on page 3-11 for an illustration of the butĆ
tons
required to select and display the menus and values. When this mode is exited, the
previ
Ć
ous print mode and LPI is restored, and all print attributes are canceled. All other format
parameters are unaffected.
1.
Place the printer off line and raise the printer cover.
2. Select and display the CONFIGURATION PRINTOUT menu in the DIAGNOSTICS
menu by pressing MENU DOWN and then PREV until DIAGNOSTICS appears in the
message
display.
3. Press MENU DOWN to display CONFIGURATION PRINTOUT in the message disĆ
play.
4. Press
RUN/STOP
. The configuration printout will print.
5. P
ress CLEAR to return to OFFLINE READ
Y.
6.
Close the printer cover and place the printer on line.