Filter
Top Products
Operation2-2
Yo u
can
also define and download an international language to allow any character within the
character library to be substituted for any code. Similarly, an individual character in a font, or
an
entire set of characters, can be created
and placed in a font. These downloading features are
discussed
in more detail in the P
rogramming chapter and the Appendix.
Power Switch
The
A
C power switch is located at the lower left corner of the rear panel of the printer. T
o turn
the
printer power on, set the power switch to the ON (|) position.
- WARNING -
The
power cord requires an IEC (hot) connector to mate to the receptacle on the rear
panel
of the printer
. The hot connector includes a polarizing key which prevents the
use
of cordsets that are not of the correct rating for the printer
.
- WARNUNG
-
Das Stromkabel benötigt einen IEC (spannungsführenden) Stecker, der in die
Steckdose an der hinteren Wand des Druckers passt. Der spannungsführende
Stecker kommt mit einem Nulleiter, der die Benutzung von Stromkabeln ohne die
korrekte
Nennleistung für den Dr
ucker verhindert.
The Control Panel
The
printer control panel
is illustrated in Figure 2-1. Each component of the control panel is
discussed on the following pages.
Status Lamps
The
status lamps are lit continuously when the printer is on line to the host and are off when the
printer
is off line. The lamps flash alternately if a fault condition exists in the printer.
Alphanumeric Message Display
The
message display shows printer status and fault
condition messages. During normal opera
Ć
tion,
the display indicates the on line status and the current print mode (and pitch) selection.