Filter
Top Products
Installation11-6
Cable Connections
Perform
the following steps and refer to Figure 11-4 to connect the cables to the printer.
1. Verify that the site line voltage is within the same range as that shown on the printer ID
label
(A) and that the proper power cord has been selected. (R
efer to the P
ower R
equireĆ
ments
section on page 11-1.)
2.
Make sure the printer power switch (B) is set to OFF (0).
3. Connect
the power cord to the printer's A
C power connector (C) and the A
C line recepta
Ć
cle.
4. Connect
the interface cable (customer supplied) to the appropriate printer interface con
Ć
nector
(D) and the host computer. R
efer to the Interfaces chapter for a complete
descrip
Ć
tion
of the printer interface.
Figure 11-4. Cable Connections