Filter
Top Products
Operation2-10
Figure 2-3. Setting Top-of-Form
Setting Top-of-Form - Reverse Paper Motion
NOTE:
Do not use this method of setting top-of-form for heavy forms or peel-off
la
Ć
bel forms.
1.
Place the printer off line and raise the printer cover.
2. Move the Forms Thickness Adjustment Lever to the fully open position. (The CHECK
indicator will light, the status lamps will flash alternately, and FAULT CONDITION
PLATEN
OPEN will be displayed.)
3. Rotate the Vertical Position Knob to align the first line to be printed with the top-of-
form
alignment indicator on the left tractor gate (Figure 2-3).
NOTE: Be sure there is enough paper extending through the tractor area so that forms
will
not run out of the tractors during the reverse feed in the following step.
4. Press and release the CLEAR and PAPER ADV switches simultaneously. The paper will
reverse feed to the top of form position on the
current
form.
5. Close the Forms Thickness Adjustment Lever to the appropriate paper thickness posiĆ
tion.
6. Press
the CLEAR switch to clear the PLA
TEN OPEN fault condition.
7.
Close printer cover and place the printer on line.