Filter
Top Products
9-8 RibbonMinder
gresses.
The ribbon life will decrease as the ribbon consumes ink. The following example
illustrates the display as the job progresses:
ON LINE 95%
DP AT 10 CPI
10. When Ribbon Life Reaches 0%
Printing can continue until the remaining usable ink reaches 0%. At this point, if the
STOP PRINTER action has been selected, the printing will stop, the printer will go off
line,
and a CHANGE RIBBON message will appear in the message display.
FAULT CONDITION
CHANGE RIBBON
11. Replace Ribbon
Open the Forms Thickness Adjustment Lever (platen). Remove the old ribbon. Install a
new ribbon and return the platen to its proper setting. Press CLEAR. The Ribbon Life
percentage
is reset to 100%.
OFFLINE 100%
READY
12. Continue Printing the Job
Press ON LINE to resume printing the job. The RibbonMinder will continue to monitor
ink
consumption and display the remaining ribbon life.
Multiple Jobs on the Same Ribbon
NOTE: The job rate for each job can be set automatically through the host interface as
discussed
on page 9-10, or set manually as discussed in this section.
The
RibbonMinder function may be used to run more than one job on the same ribbon. T
o do
this,
the JOB R
A
TE of each job must be known before printing. T
o use the function with more
than one job and more than one JOB RATE, follow the procedures for initially setting up the
RibbonMinder
function. A
t the completion of each job, change the JOB R
A
TE before starting
the
new job.
1.
Unlock P
rinter Configuration
If the printer configuration is currently locked, place the printer OFFLINE. Unlock the
printer configuration by pressing MENU UP and MENU DOWN simultaneously until
the
message ENTER SWITCH NOT LOCKED appears briefly in the message display.
ENTER SWITCH
NOT LOCKED
Message appears briefly