Filter
Top Products
Operation2-20
Fault Condition Messages
If a fault condition occurs in the printer, the CHECK light illuminates, the status lamps blink
alternately, and the first line of the message display reads FAULT CONDITION. If confiĆ
gured,
an alarm will
sound when the F
ault Condition occurs. The second line of the display will
show the specific fault. (If the specific
fault
description requires two lines, the message F
AULT
CONDITION
will not be shown.) Displayed faults fall into one of two categories:
D
Operator correctable faults
D
Field service required
NOTE: The alarm can be turned off before the fault is cleared by pressing the CLEAR
switch.
Operator Correctable Faults
Printer
problems that the operator can correct are self-explanatory and appear on the second
line
of the display:
P
APER OUT
SHUTTLE STALL
PLATEN OPEN COVER OPEN
P
APER J
AM COOLING
CHANGE RIBBON
After correcting an operator correctable fault, press the CLEAR switch before placing the
printer on line. If any other fault messages appear without an asterisk (*), press the CLEAR
switch
to continue. However,
if this problem persists, contact your authorized service represen
Ć
tative
to correct the problem permanently.
- IMPORTANT
-
If NVM INITIALIZED PRESS CLEAR appears on the display every time the
printer power is cycled, non-volatile memory must be replaced. Non-volatile
memory can be temporarily
bypassed by pressing the CLEAR switch. However, no
configuration data may be saved, and the factory default is loaded. Contact your
authorized
service representative to correct the fault permanently
.