Filter
Top Products
Interfaces7-8
n Input Buffer Size (selected from the Application Compatibility menu; refer to the
Configuration
chapter)
n
Data P
rotocol of hardware (DTR, R
everse Channel [R
C], or RTS),
X-ON/X-OFF
, A
CK/NAK or ETX/A
CK
n
Data R
ate (Baud rate selected from the control panel; external clock
jumper selected)
n
Data W
ord L
ength (7 or 8 Bits)
n
Stop Bits (1 or 2 Bits)
n P
arity (Odd, Even, or None)
n
Bit 8 F
unction (F
ont Select, PI Line, or Ignore)
n
CD and DSR signal (Enable or Disable)
n
CTS and DSR signal (Enable or Disable)
n Data T
erminal R
eady response logic
n R
equest to Send response logic
n R
everse Channel response logic
These parameters are displayed under the Application Compatibility/Host Interface/Serial
RS-232 submenu selectable from the control panel (except for external clock selection as
noted
above). R
efer to
the Control P
anel Configuration diagram in the Configuration chapter
for
detailed information on selecting the various parameter values.
NOTE:
Do not use the bit 8 function to set the PI line if the host does not use it for
paper
control;
rapid paper slewing may occur
.