Filter
Top Products
Chapter 12: Command Line Interface (CLI)
238
Setting Network Parameters
Network parameters are configured using the interface command.
admin > Config > Network > interface ipauto none ip
192.168.151.12 mask 255.255.255.0 gw 192.168.151.1 mode
auto
When the command is accepted, the device automatically drops the
connection. You must reconnect to the device using the new IP address
and the user name and password you created in the resetting factory
default password section.
Important: If the password is forgotten, the KX II will need to be
reset to the factory default from the Reset button on the back of the
KX II. The initial configuration tasks will need to be performed again
if this is done.
The KX II now has the basic configuration and can be accessed remotely
via SSH, GUI, or locally using the local serial port. The administrator
needs to configure the users and groups, services, security, and serial
ports to which the serial targets are attached to the KX II.
Note: Both IPv4 and IPv6 addresses are supported.
CLI Prompts
The Command Line Interface prompt indicates the current command
level. The root portion of the prompt is the login name. For a direct admin
serial port connection with a terminal emulation application, Admin Port
is the root portion of a command.
admin >
For SSH, admin is the root portion of the command:
admin > config > network >
0
CLI Commands
Enter admin > help.
Command
Description
config
Change to config sub menu.
diagnostics
Change to diag sub menu.
help
Display overview of commands.