Filter
Top Products
CHAPTER 2: INSTALLATION 7
CHAPTER 2: INSTALLATION
Quick Start
Important: All computers and Paragon components must be powered OFF prior to
installation.
Physical Connections:
1. Connect power cord to the Paragon Switch and power ON the unit.
Note: Step 2 applies to models UMT8 and UMT1664 only. When working with
other units, please skip directly to step 3.
2. Connect VT100 Terminator into top Expansion Port on back of the switch.
3. Connect one end of a Category 5e UTP cable to User Port # 1 on back of the Paragon switch.
4. Connect the other end of cable to RJ45 Cat5 Port on back of User Station (UST1).
5. Connect power cord to User Station (UST1).
6. Power ON UST1.
7. Connect a PS/2 keyboard, mouse and VGA monitor to UST1.
8. Power ON monitor.
9. Connect one end of a Category 5e UTP cable to Channel Port #1 on back of Paragon Switch.
10. Connect the other end of cable to RJ45 port on a Computer Interface Module (CIM).
11. Connect CIM to server’s keyboard, video, and mouse ports.
12. Power ON Server.