Filter
Top Products
CHAPTER 2: INSTALLATION 39
Perform Channel Configuration:
Paragon recognizes a HubPac as an extension of a CIM, rather than as a device. As a result, each
server connected to the HubPac is configured as a directly connected server would be.
1. On the Selection Menu (by channel ID number) each green line indicates an active channel
(CIM/computer). Highlight the CIM/server to be selected by using the <Ç> and <È> or the
<Page Up> and <Page Down> keys, then press <Enter>.
2. Normal computer access indicates successful connection. If necessary, adjust the computer’s
video quality by keying on <+> or <–> while in Hot Key mode.
3. Enter a meaningful name for each server (channel).
a. Press <F5> for the Administration Menu and select the Channel Configuration submenu.
b. On the Channel Configuration Menu, press the <Ç> or <È> keys to highlight the Name field
for channel ID where CIM/computer was just installed.
c. Press <Enter> - the highlight will turn blue.
d. Edit Name and press <Enter> when finished - the highlight will turn green as you begin to
type.
e. Press <S> to save the new name.
f. Press <F2> to return to the Selection Menu and verify that the new name appears on the
Selection Menu in green.
4. Repeat for each CIM/server desired (up to 32).