Filter
Top Products
CHAPTER 2: INSTALLATION 45
Reverse Mount Installation
Figure 32 Reverse Mount of Paragon Matrix Switch – Rack p/n RUMT-1U
Figure 33 Reverse Mount of User Station (UST1) – Rack p/n RUST-1U
Reverse Mount Installation:
1. Secure cable support bar to the front of each side bracket near the rack mount tabs.
2. Slide the Paragon Matrix Switch or User Station (UST1) between the two side brackets at the rear
end, opposite the rack mount tabs. The front of the Paragon Matrix Switch or User Station
(UST1) should be flush with the back of the side brackets.
3. Secure the Paragon Matrix Switch or User Station (UST1) to the side rack mount brackets with
three screws on each side.
4. Secure the entire assembly to the rack at the rack mount tabs.
5. Drape cables over the cable support bar.
1.
1.
2.
3.
3.
4.
4.
5.
U
M
T
8
1.
1.
2.
3.
3.
4.
4.
5.
U
S
T
1