Sun Microsystems V40z Server User Manual


 
4-24 Sun Fire V20z and Sun Fire V40z Servers—User Guide March 2005
4.5.3 DVD-ROM/Diskette Drive Assembly
The following procedure describes how to replace the DVD-ROM/Diskette Drive
assembly.
Note – Removable drives are fragile components that must be handled with care. To
prevent damage to the system, damage to a removable drive, or loss of information,
observe these precautions: Before removing a diskette drive or DVD-ROM drive, be
sure that a diskette or disc is not in the drive. Be sure that the DVD-ROM tray is
closed. While handling a drive, avoid touching the connector.
1. Power off the server, including any attached peripherals, and disconnect the
server from the electrical outlet. If your server includes two power supplies,
ensure that both power cords are disconnected from the electrical outlet.
Refer to “Powering Off the Server and Removing the Cover” on page 4-2.
2. Remove the cable service loop from the clip on the right wall of the server chassis,
including the round, black USB cable.
3. On the front panel of the server, press in the latch on the left side of the
DVD-ROM/Diskette Drive assembly and remove it from the server (see
FIGURE 4-14).
Feed the cable through the openings in the chassis as you remove the assembly.
4. Disconnect the ribbon cable connector from the rear of the assembly.
FIGURE 4-14 Removing the DVD-ROM/Diskette Drive Assembly