Sun Microsystems V40z Server User Manual


 
4-76 Sun Fire V20z and Sun Fire V40z Servers—User Guide March 2005
4.5.15 Super FRU
Caution – Only a qualified technician is allowed to perform this procedure. This
package is not a customer-replaceable unit (CRU).
Refer to the Service Label, on the inside of the chassis cover, for the location of the
components.
The Super FRU is a chassis containing the motherboard and certain
customer-replaceable units (CRUs). To install a Super FRU, you must remove all of
the CRUs from the old chassis. Then, re-install each of those components in the new
Super FRU chassis.
Note – The Sun Fire V40z Super FRU ships with the following components
installed: the PCI riser, the SCSI backplane assembly, the rear fan-cage assembly and
the operator-panel assembly.
You must remove all other CRUs from your old chassis and re-install them in the
new chassis. This includes the system cables.
1. Power off the server, including any attached peripherals, and disconnect the
server from the electrical outlet. If your server includes two power supplies,
ensure that both power cords are disconnected from the electrical outlet.
Refer to “Powering Off the Server and Removing the Cover” on page 4-2.
Some procedures might not require you to remove the cover. Refer to the individual
instructions as indicated.
2. Remove the following components and transfer them to the new Super FRU
chassis.
Refer to the appropriate instructions in this chapter to remove and replace each
component. Also refer to
FIGURE 4-2 for component locations.
PCI Card(s) (see “PCI Card” on page 4-13)
Hard Disk Drives and Carriers (see “SCSI Hard Disk Drive and Carrier” on
page 4-21)
DVD-ROM/Diskette Drive Assembly (see “DVD-ROM/Diskette Drive Assembly”
on page 4-24)
CPU Card (optional) (see “CPU Card” on page 4-25)
Individual Cooling Fans (see “Replacing an Individual Cooling Fan” on
page 4-32)
Front fan-cage assembly (see “Replacing the Front Fan-Cage Assembly” on
page 4-34)
Memory VRMs (on motherboard and CPU card) (see “Memory Voltage-Regulator
Modules” on page 4-41)