Sun Microsystems V40z Server User Manual


 
Chapter 4 Maintaining the Sun Fire V40z Server 4-29
4.5.5 Operator Panel and LCD Assembly
The following procedure describes how to replace the operator panel and liquid
crystal display (LCD) assembly.
1. Power off the system and remove the cover as described in “Powering Off the
Server and Removing the Cover” on page 4-2.
2. Remove the two non-captive screws and loosen the single captive screw that
secures the assembly to the chassis (see
FIGURE 4-19).
FIGURE 4-19 Removing the Operator Panel/LCD Assembly
3. Pull the assembly out from the chassis front about one inch, until you can reach
the two cables attached to the rear of the assembly.
4. Disconnect the two cables from the circuit board connectors on the rear of the
assembly.
5. Remove the assembly from the chassis.
6. To install the new assembly, reverse Step 2 through Step 5.
7. Check the routing of all cables for obstructions and then reinstall the cover.