e-STUDIO350/352/353/450/452/453
GENERAL OPERATION
4
4 - 9
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
A-2) Bypass misfeeding ( )
• During bypass feeding
Bypass feed clutch ON
↓
Registration sensor ON
*RegistrationsensorisnotturnedONinaxedperiodoftime(E120)
↓
Bypass misfeeding (E120)
↓
Bypass misfeeding symbol is displayed ( )
↓
Copying operation is disabled
↓
Solution: The bypass paper sensor is turned OFF by removing the paper from the bypass
tray.
A-3) Set key copy counter
• When the key copy counter (optional) is pulled out from the equipment which installs it:
“Set key copy counter” displayed
↓
Copying operation disabled
• When the counter is pulled out during copying:
Copying is stopped when the key copy counter is pulled out.
B-1) Misfeed in equipment ( )
• Exit sensor detects jamming of the leading edge of paper.
↓
Registration clutch ON
↓
Less than 1.056 sec.
Exit sensor ON
If the exit sensor is not turned ON after
1.056 seconds,
↓
Paper jam (E010)
→
The copying operation is stopped.
→
Registration clutch
Exit sensor
Timer
0
Paper jam (E010)
ON
ON
1.056sec.
Fig. 4-301