Toshiba 353 All in One Printer User Manual


 
6
6 - 20e-STUDIO350/352/353/450/452/453
SCANNER
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(6) Rotate the carriage-1 in the direction shown
inthegureatright,nottotouchthemirror.
Then take off the carriage-1.
Note:
Wheninstallingthecarriage-1,xthe
bracket temporarily at the position (A). Then
move it to the direction (B) slowly, push it to
theendofframeandxatthispositionwith
the screws. (Refer to 3.7.1 in the Service
Handbook.)
(
B
)
(
A
)
(
A
)
Fig. 6-718
Fig. 6-719
Fig. 6-716
Fig. 6-717
Black line
Lamp harness Lamp harness
Seal
Hole
Punched mark
Lamp harness
Seal
Punched mark
Note:
Make sure to hold only the black molded
part of the exposure lamp. Do not touch any
other part than this black molded part.
1. Using alcohol, clean the area where
the seal is to be attached..
2. Align the black line on the lamp harness
withthepositionasshowninthegure,
andxitwithaseal.
3. Align the bent portion of the lamp
harness with the position as shown in the
gure,andxitwithaseal.
4. After the installation, move carriage-1
towardstheleftandconrmthatthereis
no abnormality in the lamp harness, such
as twisting.
07/03