Filter
Top Products
9 - 20
9
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-443
Fig. 9-442
Fig. 9-441
Fig. 9-440
[C]
Registration sensor, Upper drawer feed sensor
(1)
Take off the front cover ( Chapter 2.5.1 [A]).
(2)
Take off the front right cover ( Chapter 2.5.1 [B]).
(3)
Take off the right upper cover ( Chapter 2.5.1 [O]).
(4)
Take off the cleaner unit
( Chapter 11.6 [A]).
(5)
Take off the IH terminal cover ( Chapter 2.5.1 [F]).
(6)
Take off the right rear cover ( Chapter 2.5.1 [G]).
(7) Remove 1 screw and take off the front cover
stay.
(8) Release the latch from the shaft and take off
(9) Remove 1 screw and take off the terminal
cover.
(10) Remove 1 screw and disconnect the red
lead wire from the terminal cover.
Note:
Make sure that the harness is inserted into
the dent of the terminal cover when install-
ing.
(11) Disconnect 2 connectors.
Front cover stay
Jam
release knob
Terminal
cover
Lead wire
Connector
Latch
Screw
the jam release knob.
Screw