Filter
Top Products
9 - 24
9
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-457
Fig. 9-456
Fig. 9-455
[E] Tray drive unit/Tray-up motor
(1) Remove the upper and lower drawers.
(2)
Take off the rear cover ( Chapter 2.5.1 [H]).
(3) Take off the right rear hinge cover
( Chapter 2.5.1 [D]).
(4) Remove 4 screws and take off the right
lower cover ( Chapter 2.5.1 [E]).
(5) Remove 4 screws and take off the noise
lterassembly.
(6) Disconnect 1 connector of the tray drive unit
and release the harness from the harness
clamp.
(7) Remove 5 screws and take off the tray drive
unit with the plate.
(8) Remove 4 screws and detach the tray drive
unit from the plate.
Fig. 9-454
(18) Take off the registration roller (metal).
(front side: 1 E-ring, 1 bushing and 1 spring,
rear side: 1 E-ring, 1 bushing and 1 spring)
Screw
Screw
Screw
Screw
Connector
Tray drive unit
Noiselter
assembly
Registration
roller (metal)
Spring
Spring
E-ring
E-ring
Bushing
Bushing
Screw
06/03