Filter
Top Products
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
9
9 - 15
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-421
Fig. 9-422
Bypass pick up roller
Timing belt
Clip
Shaft
Clip
Bypass feed roller
(A-7) Bypass feed roller
(1)
Take off the bypass unit ( Chapter 9.4 (A-1)).
(2) Take off the bypass feed upper cover
( Chapter 9.4 (A-6)).
(3) Take off the bypass drive unit ( Chapter
9.4 (A-6)).
(4) Remove the clip, pull out the shaft and take
off the bypass feed roller.
Note:
Make sure the following items when assembling
the bypass feed roller and bypass pickup roller.
1. Set the timing belt to the pulley securely.
2. Do not put the wrong position when set
ting the timing belt.
3.
Be sure to insert the clip into the groove of shaft.
4.
Check that there is no stain such as oil on the
surface of timing belt, the pulley and the roller.
5. Install the bypass pickup roller and the
bypass feed roller in the correct direction.
Fig. 9-423
E-ring
Bushing
Bypass transport roller
Bushing
(A-8) Bypass transport roller
(1) Take off the bypass feed upper cover
( Chapter 9.4 (A-6)).
(2) Take off the bypass drive unit ( Chapter
9.4 (A-6)).
(3) Remove the E-ring, pull out the shaft and
take off the bypass transport roller.
(4) Remove the clip, pull out the shaft and take
off the bypass pickup roller.