Toshiba 353 All in One Printer User Manual


  Open as PDF
of 302
 
5 - 4
5
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO350/352/353/450/452/453
CONTROL PANEL
No. Message State of equipment Note
20 READY
(SADDLE STITCH
TRAY FULL)
Saddle stitcher tray is full of paper
- Scanning is enabled
21 READY
(CHANGE DRAWER
TO CORRECT
PAPER SIZE)
Incorrect paper size setting
22 Ready for bypass
feeding
Paper is set on the bypass tray
23 COPYING At the copying state
24 Auto Start Auto Start is set during printing Cleared by pressing [RESET] button
or [STOP] button
25 Close Large Capacity
Feeder
LCF drawer is not installed when feeding
from LCF is set
Cleared by installing LCF drawer
26 Close Large Capacity
Feeder Door
LCF cover is open when feeding from LCF
is set
Cleared by closing the cover
27 Place Doc. Feeder in
the down position
RADF is open when original is placed on
RADF
Cleared by closing RADF
28 Insert key copy
counter
Key copy counter not inserted Cleared by inserting key copy counter
29 Place originals in the
document feeder
Displayed when the conditions are set and
START button is pressed with no original
placed
Cleared by setting the original
30 Change direction of
original
Displayed when the direction of original
placed is different from the setting
31 Place last %d
originals in doc.
feeder entrance tray
Paper jam occurred during copying (RADF
scanning)
32 Add paper Displayed when the paper in selected
drawer is running out
33 Cannot duplex this
size
Displayed when the paper size which is not
speciedforduplexcopyingisset
34 Cannot use this
media type
Displayed when the paper size which is not
speciedforthefunctionssuchasstapling
or hole punching is set
35 Copy size: A4/LT
only
Displayed when the paper size which is not
speciedfor“Book-typeduplexcopying”or
“Dual-page” is set
36 Copy size: A4/LT and
A4-R/LT-R
Displayed when the paper size which is not
speciedfor“RotateSort”
37 CHANGE DRAWER
TO CORRECT
PAPER SIZE
Displayed when the selected paper size is
not in the drawer
38 Change drawer to
correct media type
Displayed when the selected media type is
not in the drawer
39 Select a paper size
for bypass feeding
Displayed when paper size needs to be
speciedforbypassfeedingsuchasduplex
copying
 previous next