Toshiba 353 All in One Printer User Manual


  Open as PDF
of 302
 
13 - 2
13
e-STUDIO350/352/353/450/452/453
FUSER UNIT / PAPER EXIT SECTION
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
13.3 Functions
(1) IH coil (IH: Induction Heating)
The IH coil is inside the fuser roller and applies the induction heating to the fuser roller. The coil is
xedatapositionanddoesnotmovewhenthefuserrollerisrotating.
(2) Fuser roller
The fuser roller is a metal roller which generates heat spontaneously with eddy current produced
by the electromagnetic induction of IH coil. The fuser roller is heated by this self-heating of this
roller, and then the toner is fused on the paper.
(3) Pressure roller
The pressure roller is a sponge roller which assures the nip amount between the fuser roller. The
pressure arm and spring press the fuser roller.
The toner is fused effectively by the pressure of this roller.
(4) Separationngers
Theseparationngersareinstalled,veabovethepressurerollerandsixabovethefuserroller,
in order to separate the paper adhered on each roller.
(5) Cleaning roller
Thecleaningrollerisauorinatedmetalrollerwhichremovestheresidualtonerandpaperdust
adhered on the pressure roller.
(6) Main thermistor
This thermistor detects the temperature of the fuser roller to maintain it in a certain temperature
range (actually around 200°C) between the lower limit causing the poor fusing and the upper limit
causing the high temperature offsetting. When the temperature of the fuser roller is lower than
the preset temperature, it turns ON the power supply to the IH coil, and when it is higher than the
preset temperature, it cuts off the supply.
(7) Edge thermistor
It detects the temperature abnormality at the both ends of the fuser roller. This area may be
overheated without heat absorption by paper since paper does not pass through this area. This
thermistor is not related to the temperature control of the fuser roller.
 previous next