Filter
Top Products
2 - 42
2
2
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 2-608
(4) Remove2screwsandtakeoff2xing
brackets on the rear side.
Fig. 2-605
Fig. 2-606
Fig. 2-607
Connector of optional
damp heater
(6) Remove 2 screws on the front side.
(7) Slide the RADF backward and take off by
lifting it up.
[B] KD-1011 (Paper Feed Pedestal (PFP))
(1) Turn OFF the power and unplug the power
cable.
(2) Take off the rear cover of the equipment.
( Chapter 2.5.1 [C])
Note:
DisconnecttheconnectoroftheRADFrst
when the RADF is installed.
(3) Remove 1 screw and the ground wire, and
then disconnect 2 connectors (3 if the op-
tional damp heater is installed).
05/11