Toshiba 353 All in One Printer User Manual


 
13 - 18
13
e-STUDIO350/352/353/450/452/453
FUSER UNIT / PAPER EXIT SECTION
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 13-709
Fig. 13-710
Fig. 13-711
Fig. 13-712
[E] Separation nger for pressure roller
(1) Take off the fuser unit ( Chapter 13.7 [A]).
(2) Open the fuser unit cover and transport
guide.
(3) Take off the guide by removing 1 screw for
eachnger.
(4) Remove 5 springs and take off 5 separation
ngersforpressureroller.
[F] Separation nger for fuser roller
(1) Take off the fuser unit ( Chapter 13.7 [A]).
(2) Open the fuser unit cover and transport
guide.
(3) Remove 2 screws (one on the front side is
a stepped screw) and take off the paper exit
unit.
(4) Remove 6 springs and take off 6 separation
ngersforfuserroller.
[G] Cleaning roller
(1) Take off the fuser unit ( Chapter 13.7 [A]).
(2) Take off the fuser unit cover ( Chapter
13.7 [B]).
(3) Release the harness from the harness guide
of the cover on the rear side.
(4) Remove 1 screw and take off the cover on
the rear side.
Stepped screw