Toshiba 353 All in One Printer User Manual


  Open as PDF
of 302
 
e-STUDIO350/352/353/450/452/453
CONTROL PANEL
5
5 - 3
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5.2.1 Display
No. Message State of equipment Note
1 - Power is OFF (at Sleep Mode) Press [START] button or [FUNCTION]
button to clear
2 Saving energy -
press START button
At Energy Saving Mode Press [START] button to clear
3 Wait Warming Up Scanner warming up
- Displayed until the equipment becomes
ready to start scanning
Auto Start can be set
4 Wait Warming Up
Auto Start
Scanner warming up
- Displayed when Auto Start is set
Press [STOP] button to clear the Auto
Start.
5 WAIT Displayed when performing the controlling
function to keep the equipment at the best
condition
6 Wait adding toner Supplying toner
- Equipment becomes the toner supply state
Recovers when the toner supply has
nished
7 Performing Auto
Calibration
Displayed at image quality control Recovers when the image quality
controlhasnished
8 READY Ready for copying
- Waiting for the operation
9 READY
Press START button
to copy
Copying job interrupted Press [START] button to resume
copying or press [MEMORY CLEAR]
button to delete the job
10 READY
(WARMING UP)
Scanner warming up
- Ready to scan the original
11 READY
(PRINTING)
Printing out the data
- Scanning is enabled
12 READY
(ADDING TONER)
Supplying toner
- Scanning is enabled
13 READY
(INNER TRAY FULL)
Receiving tray in the equipment is full
- Scanning is enabled
- When the bridge unit is installed
- Resumes printing by removing
papers from the tray
14 READY
(CHECK STAPLER)
Nostaplesinnisher
- Scanning is enabled
Cleared by supplying the staples
15 READY
(CHECK STAPLER)
Staplingjamoccurredinnisher
16 READY
(CHECK SADDLE
STITCH STAPLER)
No staples in saddle stitcher
- Scanning is enabled
Cleared by supplying staples
17 READY
(ADD PAPER)
Press JOB STATUS
button
No paper in drawer
- Scanning is enabled
Cleared by supplying papers
18 READY
(FINISHER FULL)
Finisher is full of paper
- Scanning is enabled
Resumes printing by removing paper
fromthenisher
19 READY
(HOLE PUNCH
DUST BIN IS FULL)
Punching dust box is full
- Scanning is enabled
Resumes printing by removing
punching dust from the dust box
 previous next