Filter
Top Products
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
9
9 - 17
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(A-11) Bypass feed sensor
(1)
Take off the bypass unit ( Chapter 9.4 (A-1)).
(2) Take off the lower plate ( Chapter 9.4
(A-10)).
(3) Remove 1 screw and take off the sensor
plate.
(4) Disconnect 1 connector, release the latch to
take off the bypass feed sensor.
Note:
Be careful not to come off the sensor arm
and the sensor spring after taking off the
sensor.
Fig. 9-431
Fig. 9-430
Sensor plate
Screw
Sensor Spring
Sensor arm
Bypass feed sensor
(4) Detach the cover, the arbor, and the clutch
spring from the shaft, and then take off the
bypass separation roller.
Fig. 9-429
Bypass separation
roller assembly
(3) Take off the bypass separation roller assem-
bly.
Fig. 9-428
Shaft
Bypass separation roller
Cover
Clutch
spring
Arbor