Filter
Top Products
2 - 40
2
2
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 2-554
[G] High-voltage transformer
(1)
Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Disconnect 7 connectors.
(3) Remove 2 screws and release 2 locking
supports. Then take off the high-voltage
transformer.
Note:
When installing, make sure to match the
colors of connectors and harnesses accord-
ing to the color instruction on the board.
Fig. 2-555
[H] Noise lter
(1) Take off the rear cover and right lower cover
( Chapter 2.5.1 [C] [O]).
(2) Disconnect 4 connectors. Remove 1 screw
and1washer.Thentakeoffthenoiselter.
White Black
Fig. 2-553
[F] Power supply cooling fan
(1) Take off the left cover ( Chapter 2.5.1 [J]).
(2) Remove 2 screws and take off the power
supply cooling fan on the switching power
supply.
Note:
When installing, pay attention to the direction
of the wind from the fan.
(3) Disconnect 3 connectors while the switching
power supply is pulled out to the front and
take off the switching power supply.
Fig. 2-552