Toshiba 353 All in One Printer User Manual


  Open as PDF
of 302
 
5 - 6
5
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO350/352/353/450/452/453
CONTROL PANEL
04/01
No. Message State of equipment Note
59 Cannot use AMS
mode
Displayed when reproduction ratio is set to
be over 200% at AMS Mode on RADF
Set the reproduction ratio 200% or
below manually
60 More than 200% is
not available
Displayed when reproduction ratio is set
manually to be over 200% on RADF
Set the reproduction ratio 200% or
below
61 Updated the template
setting
Displayed when the template stored is
recalled by pressing [TEMPLATE] button
62 Enter Department
Code
Displayed when a button is pressed while the
department management setting is available
63 Cannot copy Check
DEPARTMENT
COUNTER
Displayed when the number of printouts
exceeds the limit number of department
counter
64 Not enough memory
to store original(s)
Will you print out
stored originals?
Displayedwhenconrmingtheusertoprint
out the data as much as stored at memory
- full state
65 Not enough memory
to store original(s)
Will you send stored
originals in?
Displayedwhenconrmingtheusertosend
the FAX data as much as stored at memory
- full state
Displayed only in FAX Function
66 Not enough memory
to store original(s)
Will you save stored
originals in?
Displayedwhenconrmingtheusertosave
the scanning data as much as stored at
memory-full state
Displayed only in FAX Function
67 The number of
originals exceeds the
limits Will you copy
stored originals?
Displayedwhenconrmingtheusertoprint
out the data as much as stored at memory-
full state
68 The number of
originals exceeds the
limits.
Will you send stored
originals?
Displayedwhenconrmingtheusertosend
the FAX data as much as stored at memory-
full state
Displayed only in FAX Function
69 The number of
originals exceeds the
limits.
Will you save stored
originals?
Displayedwhenconrmingtheusertosave
the scanning data as much as stored at
memory-full state
Displayed only in Scanning Function
70 Install new toner
cartridge
No toner in the cartridge Displayed when toner is running out.
Copying not enabled
71 Time for periodic
maintenance
PM cycle
- Displayed at the time for maintenance
- Copying is available
Maintenance and inspection are
performedbyqualiedservice
technician.
72 READY
(CHANGE DRAWER
TO CORRECT
MEDIA TYPE)
Displays when the printing is stopped
because of media type mismatch
73 PRESS [BASIC]
and select normal
paper size
Displays the warning that the copy is not
enabled when any drawer but bypass feed
is selected at Cover Sheet Mode or Sheet
Insertion Mode.
 previous next