Toshiba 353 All in One Printer User Manual


 
e-STUDIO350/352/353/450/452/453
GENERAL OPERATION
4
4 - 11
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
During paper feeding from the equipment or PFP:
RegistrationsensorisnotturnedONinaxedperiodoftimeafterthefeedclutchisturned
ON
Paper jam (E220, E310, E320, E340–E360, E3D0 and E3E0: Error code differs depending
on the paper source.)
B-2) Add toner ( )
Toner density becomes low
Auto-toner sensor detects the absence of the toner
Control circuit
“Add toner” displayed: the copying operation disabled
Solution: Open the front cover and replace the toner cartridge with a new one.
Toner is supplied
copying operation enabled.
B-3) Developer unit not installed properly
Disconnection of the connectors of the developer unit
“Developer unit not installed” is displayed.
Solution: Connect the connectors of the developer unit and close the front cover.
B-4) Dispose of used toner ( )
Toner bag becomes full of toner
Toner recovery auger shifts to the rear side: Toner bag full detection sensor (1) ON or Toner bag
detection sensor (2) ON
“Dispose of used toner” is displayed.
Toner bag full detection sensor ON during printing
Printing is stopped after the paper being printed is exited.
Solution: Replace the toner bag with a new one and close the front cover.
C-1) Call for service
Error code is displayed instead of the set number by pressing the [CLEAR] button and [8] button
simultaneously when the “Call for service” is blinking.
Refer to the error code table in the Service Handbook.