Toshiba 353 All in One Printer User Manual


  Open as PDF
of 302
 
2 - 43
2
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(7) Lift up the equipment and take off the PFP.
Fig. 2-609
Fig. 2-610
Fig. 2-611
(5) Take off the lower drawer of the equipment
and PFP upper drawer.
(6) Remove4screwsandtakeoff2xing
brackets on the front side.
Fig. 2-612
Connector of optional
damp heater
[C] KD-1012 (Large Capacity Feeder (LCF))
(1) Turn OFF the power and unplug the power
cable.
(2) Take off the rear cover of the equipment.
( Chapter 2.5.1 [C])
Note:
DisconnecttheconnectorsoftheRADFrst
when the RADF is installed.
(3) Remove 1 screw and the ground wire, and
then disconnect 2 connectors (3 if the op
-
tional damp heater is installed).
05/11
 previous next