Filter
Top Products
e-STUDIO350/352/353/450/452/453
SCANNER
6
6 - 21
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[J] Carriage wire / Carriage-2
(1) Take off the carriage-1 ( Chapter 6.7 [G]).
(2) Install the wire holder jig to each pulley on
front and rear sides, not to loosen the car-
riage wire.
Note:
Refer to “3.9 Adjustment of Carriages” in
the Service Handbook for the installation
direction of the wire holder jig.
(3) Remove the tension springs on both front
and rear sides.
(4) Remove the carriage wires on both front and
rear sides.
[I] INV board
(1) Take off the carriage-1 ( Chapter 6.7 [G]).
(2) Disconnect 2 connectors.
(3) Remove 2 screws and take off the INV
board.
[H] Mirror-1
(1) Take off the carriage-1 ( Chapter 6.7 [G]).
Note:
When replacing the mirror-1, replace the
carriage-1 together with mirror-1.
Mirror-1 should not be removed.
Fig. 6-721
Fig. 6-722
Tension spring
Fig. 6-720