Toshiba B-570 SERIES Printer User Manual


 
6-3
EM18-33010A
6. DIAG. TEST OPERATION
(Revision Date Jan. 14, ’99)
6.2 SELF TEST MODE
6.2 SELF TEST MODE
In self test mode the printer status is printed in two types of sample print. The result of the head broken
element check is indicated in the display.
6.2.1 Maintenance Counter Printing
The data from 1 to
31
on a sample print is printed. This data is the printer status and the value
set in the parameter setting mode.
NOTES: 1. If the maintenance counter printing results in an error, the printer will display the error
message and stop printing. The error status can be cleared by the [PAUSE] key,
however, the display will return to the initial display “<1> DIAGNOSTIC V1.0A”.
Printing is not automatically resumed after the error is cleared.
2. Both label and tag paper can be used for printing.
<
1 DIAGNOSTIC V1.0A
>
R
I BON TRANSMISSIVE
B
M
A NTENANCE COUNTER
I
C
H CKING & PRINTING
E
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [PAUSE] key.
Select the ribbon type from those
at the right by pressing the
[FEED] key or [RESTART] key.
Press the [PAUSE] key.
Press the [PAUSE] key.
The result of the self test
is printed. After printing,
the initial display will be
shown.
Press the [PAUSE] key.
Continued on Section 6.2.2
Automatic Diagnostics Printing.
NO RIBBON (No ribbon : Thermal direct)
TRANSMISSIVE
(Transmissive ribbon : Thermal transfer)
NO TRANS.
(Non-transmissive ribbon : Thermal transfer)
[
The printer is checking or printing
the status
]