Filter
Top Products
3.20 IEEE1394 Test Program 3 Tests and Diagnostics
TECRA M1 Maintenance Manual (960-436) 3-51
3.20 IEEE1394 Test Program
This section describes how to perform the IEEE1394 test with the test program.
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
(a) Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
***********************************************************************
* ------------------------------------------------------------ *
* IEEE1394 [TSB!”LV28] test menu ( For Repair ) VX.XX *
* ------------------------------------------------------------ *
* *
* ============ Select test No. and [Enter] ============ *
* *
* 1 : ... Ieee1384 test *
* 2 : ... Responder tool *
* 3 : ... ID Check *
* *
***********************************************************************
Select [1-3]?
(b) To execute the TEST, select the test number you want to execute and press Enter.