Filter
Top Products
4.25 Fluorescent Lamp 4 Replacement Procedure
TECRA M1 Maintenance Manual (960-436) 4-97
4. Setting bezel
1) Hook the bezel on the five latches of the frame from the upper side.
NOTE: 1) Make sure the GND-CU on the left side and lamp reflector shall be
inside the bezel.
2) Be careful not to damage the TAB.
3) Make sure the five latches of the upper side of bezel are hooked on.
The cable shall not be
outside the bezel.
Make sure the gum projection
for protecting the cable is not
outside
th
ebezel.
(2) Align the bezel with the
lamp side of the backlight unit.
(1) Install the bezel from the
TAB side. Be careful not to
damage the TAB. Hook the
bezel on the five latches.
Make sure the fold of reflector
is not outside the bezel.
Make sure the gum projection
for protecting the cable is not
outside
th
ebezel.
Figure 4-59 Replacing TOSHIBA fluorescent lamp (XGA) (9)