Filter
Top Products
4.8 CPU 4 Replacement Procedures
TECRA M1 Maintenance Manual (960-436) 4-29
M2.5×16 FLAT HEAD screw
M2.5×4 FLAT HEAD screw
CPU cover
A
Slot
M2.5×4 FLAT HEAD screw
Figure 4-11 Removing the CPU cover
2. Remove the following screws securing the CPU holder. Lift the “2” side of the CPU holder
first, then rotate the holder 90 degrees counterclockwise. Then lift the “1” side of the CPU
holder and remove the holder.
• M2×6 BIND screw ×4
3. Remove the fin.
CAUTION: Silicon grease is applied between the fin and the CPU. When
removing the fin, be careful not to damage the CPU under the fin.