Filter
Top Products
4 Replacement Procedure 4.25 Fluorescent Lamp
4-96 TECRA M1 Maintenance Manual (960-436)
3. Folding and temporary fixing of TAB/PCB
1) Fold the X-TAB (X-PCB) and Y-TAB (Y-PCB) to the back of backlight unit.
2) Hook the X-PCB on the three latches on the back of frame.
NOTE: Be careful not to damage the TAB.
(1) Fold the X-PCB to the back.
(2) Fold the Y-PCB
to the back.
Insert the FPC into the connector.
The PCB shall not be
installed over the frame.
The PCB shall be hooked on the
three latches of the frame.
Figure 4-58 Replacing TOSHIBA fluorescent lamp (XGA) (8)