Filter
Top Products
4 Replacement Procedures 4.10 Memory Module
4-36 TECRA M1 Maintenance Manual (960-436)
4.10 Memory Module
Removing a Memory Module
To remove a memory module, make sure the computer is in boot mode and powered off, follow the
steps below and refer to figure 4-18.
CAUTION: 1) Do not try to remove a memory module with the computer turned on.
The computer or the memory might be damaged.
2) Do not touch the connectors on the memory module(s) or on the
computer. Debris on the connectors may cause memory access problems.
1. Turn up the insulator covering the memory slots.
2. Press the two latches outward. One end of the memory module will pop up.
3. Grasp the memory module and pull it out to remove the memory module from PJ1001 (Slot
A) or PJ1002 (Slot B) on the system board.
Insulator
Latches
Memory module
Memory slot B
Memory slot A
Figure 4-18 Removing the Memory module