Filter
Top Products
4.14 Bluetooth Module 4 Replacement Procedures
TECRA M1 Maintenance Manual (960-436) 4-47
4.14 Bluetooth Module
Removing the Bluetooth Module
To remove the Bluetooth module, follow the steps below and refer to figure 4-25.
CAUTION: Do not try to remove the Bluetooth module with the computer turned on.
You can damage the computer or Bluetooth module. Do not touch the connectors on the
Bluetooth module on the computer. Debris on the connectors may cause Bluetooth access
problems.
1. Remove the Bluetooth coaxial cable (brown) from the Bluetooth module using an antenna
coaxial cable disconnector.
2. Remove the following screw securing the Bluetooth module.
• M2×3 SUPER FLAT screw ×1
3. Lift up the Bluetooth module and disconnect the Bluetooth SUMI card from PJ4900 on the
system board.
4. Remove the Bluetooth SUMI card from the connector on the Bluetooth module.