Filter
Top Products
4 Replacement Procedures 4.16 LED Board
4-54 TECRA M1 Maintenance Manual (960-436)
4.16 LED Board
Removing the LED Board
To remove the LED board, follow the steps below and refer to figure 4-29.
1. Remove the glass tape securing the LED board SUMI card and USB cable.
2. Disconnect the LED board SUMI card from PJ1101 on the system board.
3. Remove the following screws securing the LED board and remove the LED board.
• M2.5×4 FLAT HEAD screw ×2
4. Disconnect the LED board SUMI card from PJ3100 on the LED board.
M2.5
×
4 FLAT HEAD screw
LED Board
LED board SUMI card
PJ1101
PJ3100
Glass tape
USB cable
M2.5×4 FLAT HEAD screw
Figure 4-29 Removing the LED board