Filter
Top Products
3 Tests and Diagnostics 3.29 SETUP
3-92 TECRA M1 Maintenance Manual (960-436)
When the Printer Port Mode (see settings below) is set to ECP, the DMA channel
can also be set to 1, 2 or 3. The default is 3.
LPT setting Interrupt level I/O address DMA channel
LPT 1 7 378H 3 (Parallel port default)
LPT 2 5 278H 3
LPT 3 7 3BCH 3
Not Used Disables the port
When you select one of the above options, except for Not Used, a subwindow
similar to the one below appears to let you set the DMA. The options for this setting
are Channel 1and Channel 3 (Default).
For most printers, the port should be set to ECP. With some other parallel devices,
the setting should be Std. Bi-Direct.
10. Drives I/O
This option displays the address and interrupt level for hard disk drive, CD/DVD-ROM
drive and PC card. It is for information only and cannot be changed.
(a) Built-in HDD
Primary IDE (1F0H/IRQ14) The Built-in HDD is ready for use.
No Drive The Built-in HDD is not installed.
(b) Select Bay
This option is displayed only when the hard disk drive or optical disk drive is
installed to the select bay. Secondary IDE (170H/IRQ15) Computer Selectable
Bay HDD.
(c) PC Card
When an ATA card is installed in IN13h, the sub window below is displayed.
DMA
= Channel 3 (Default)
OPTIONS
Built-in HDD = Primary IDE (1F0H/IRQ14)
ATA Card = Others (190H/IRQ)
DRIVES I/O