Filter
Top Products
Installing Printer Options
Appendix C: Printer Options ❖ C-3
Installing Printer Options
You can customize your printer by changing memory
capacity and installing different connectivity options.
This chapter provides instructions for installing each
option. To install each option, you must first access the
printer system board. Access is from three locations
depending upon the option you are installing:
• Under the input tray and output bin unit on the front
of the printer
• The back of the printer, and
• The right side of the printer (when facing the front of
the printer).
Table C.1 lists printer options, where to access them, and
where to find installation instructions.
Table C.1 Installing Options
Option Location of System Board Access Go to...
Printer memory Under the input tray page C-4
Flash memory On the back of the printer page C-9
Tri-Port interface card On the right side of the printer page C-17
Hard Disk On the right side of the printer page C-20
You need a small Phillips screwdriver to complete the
installation of some options.