Filter
Top Products
Flash Memory
C-12 ❖ DocuPrint C20/NC20 User Guide
4
Hold the SIMM with the connection points pointing
toward the connector and position the notch as shown.
5
Insert the SIMM all the way into the connector at a 45°
angle, and rotate it
up
until it snaps into place.
You can hear the memory SIMM click into place.
6
Make sure both metal clips on the connector are fastened,
and the two pins on each end of the connector are pushed
through the holes on the SIMM.
7
Replace the code SIMM card in the connector.
The code SIMM card installs exactly like the flash memory
option. See the section
“Installing a Flash Memory SIMM”
on the previous page.
8
Continue with the section
“Closing the System Board from
the Rear”
on the next page.