Filter
Top Products
Flash Memory
Appendix C: Printer Options ❖ C-13
Closing the System
Board from the Rear
Complete the following steps to close the Printer System
Board after you have installed the flash memory SIMM:
1
Push on the access cover until it snaps into place.
2
Do one of the following:
• Reattach the printer rear cover.
- Insert the two tabs on the bottom of the cover into
the slots on the back of the printer, as shown.
- Push the cover forward until it snaps firmly into
place.
• Reinstall the optional Tray 2 (if one was attached). If
you need help, see the section
“Input Tray 2”
(page C-25).