Filter
Top Products
6287 ULTRA Users ManualPage 13-2
VTAM and Network Control Program
Requirements
The 3174, 3274 or 3276 control unit to which the ULTRA is attached must
be defined as a type 2 physical unit and the logical unit (type 1 or 3)
definition must be included for each ULTRA to be attached. The following
is an example of log mode entry tables for DSC and SCS that may be used
with the ULTRA. If necessary, consult with the Company System Manager
regarding specific requirements for the system, environment and
applications.
DSC2K MODEENTLOGMODE=DSC2K
BIND USED FOR APPLICATION SESSIONS
FMPROF=X03' FUNCTION MANAGEMENT PROFILE
TSPROF=X03' TRANSMISSION SERVICES PROFILE
PRIPROT=XB1' PRIMARY PROTOCOL
SECPROT=X90' SECONDARY PROTOCOL
COMPROT=X3080' COMMON PROTOCOL
RUSIZES=X8787' PRI RUSIZE=1024, SEC RUSIZE=1024
PSERVIC=X030000000000185018507F00'
LU SERVICES PROFILE
SCS MODEENT LOGMODE=SCS
BIND USED FOR APPLICATION SESSIONS
FMPROF=X03' FUNCTION MANAGEMENT PROFILE
TSPROF=X03' TRANSMISSION SERVICES PROFILE
PRIPROT=XB1' PRIMARY PROTOCOL
SECPROT=X90' SECONDARY PROTOCOL
COMPROT=X3080' COMMON PROTOCOL
RUSIZES=X87C6' PRI RUSIZE-768, SEC RUSIZE=1024
PSNDPAC=X01' PRIMARY SEND PACING COUNT
SRCVPAC=X01' SECONDARY RECEIVE PACING COUNT
PSERVIC=X01000000E100000000000000'
LU SERVICES PROFILE
APL Support
APL is supported only for DSC data streams when the ULTRA is
outputting data using the ASCII character set. When using APL, the DSC
log mode entry table above will be the same except for the last line,
PSERVIC=X' . A change must be made to the byte following the
X'03. The second byte (00) must be changed to another value, depending
upon the device for which the users application was written. The following
table indicates the appropriate replacement value.