Filter
Top Products
Page 5-9CONFIGURATION OPTIONS
34 SCS Trigger 1
Determines which SCS character will be used (in conjunction with either
Trigger 2 or a Count Byte, depending upon the setting of Option #30) to
signal the start of PTM. The user may enter any two-character hexadecimal
value that will not otherwise be found in the data stream. The default value
is an SCS cent sign (¢) 4Ah. Refer to Section 11 Transparency Modes
for more information. This character is also used as a trigger for
configuring the ULTRA, invoking PFSs and programming PFSs from the
coax host.
Note: The Trigger 1 character should be reserved for this use only. Any
other use of the Trigger 1 character may produce unpredictable results.
35 SCS Trigger 2
Determines which SCS character must follow Trigger 1 in order to start
PTM when Option #30 is set to (A). The user may enter any two-character
hexadecimal value, except for 6Fh (?), 6Ch (%), 5Ah (!) and 50h (&),
which are used by the ULTRA for other purposes. The default value is an
SCS dollar sign ($) 5Bh. Refer to Section 11 Transparency Modes for
more information.
36 Reserved
This option is reserved.
37 Reserved
This option is reserved.
38 Reserved
This option is reserved.
39 Non-Transparency Trigger 1 Output
Determines the character that will be sent to the printer when Option #30 is
set to (A) and the Trigger 1 character is not followed by the Trigger 2
character. The user may enter any two-character hexadecimal value. The
default value is 9Bh. Refer to Section 11 Transparency Modes for more
information.