Filter
Top Products
CONFIGURATION OPTIONS
General Information
This section describes each of the parameters of the General Configuration
Options that the user can select to adapt the ULTRA to the users specific
environment.
Configuring the ULTRA changes the way in which it handles the data
stream from the coax host or alternate host before the data is sent to the
printer or plotter. The configuration option parameters allow the user to
change printer output, page formatting, host parameters, transparency
modes, etc. Under many circumstances, the ULTRA configuration will not
have to be modified, because it is already set up for the most common
environments.
Before changing any of the configuration settings, the user should print a
General Configuration Report that will display the current settings. A
General Configuration Report can be generated by pressing the TEST
button on the front panel of the ULTRA when the unit is in normal
operating mode. A sample report can be found in the Appendix.
The most critical part of configuring the ULTRA is correctly choosing the
output settings. If the users printer or alternate host operates in serial mode,
refer to Section 3 Dip Switch Settings before continuing.
Besides the limited number of functions determined by the dip switch
settings, there are three ways to configure the options of the ULTRA. They
can be configured from the ULTRA front panel with some limitations, or
they can be configured from the coax host or from an alternate host. Each
of the three methods of configuring the ULTRA is described in a
subsequent section.
The easiest method of changing the ULTRA options is from the front panel,
but some variables cannot be selected. Programmable function strings
(PFSs) and translate tables are editable only from the coax host or from an
alternate host.
SECTION 5