Page 5-3CONFIGURATION OPTIONS
3 Line Spacing
This option allows the user to set line spacing to any value between 1 and 9.
Any line feeds received from the coax host or sent out by the ULTRA are
multiplied by the value of this option. The default is 1 (single spacing).
4 Local Copy Null Line Suppression
In a local copy or DSC print job, this option determines whether or not lines
containing only nulls are printed. The default value is Yes.
5 Xerox 36 Hex Transparency
If this option is set to Yes, Xerox 36 Hex transparency is enabled. If this
option is set to No, 36h will be ignored. The default value is No. Refer
to Section 11 Transparency Modes for more information.
Note: If this option is set to Yes, Option #1 Column width should be
set to 0 (infinite line length), Option #2 Lines Per Page should be set to 0
(infinite page length), and Option #15 Bold Print Emulation should be
set to C (none). Otherwise, unpredictable formatting errors could occur.
Refer to Section 12 DisplayWrite 370 Support for more information.
6 Form Feed Before Local Copy
Determines whether or not a form feed will be sent to the printer before
beginning a local copy. The default value is No.
7 Form Feed After Local Copy
Determines whether or not a form feed will be sent to the printer after
finishing a local copy. The default value is Yes.
8 New Line Order
Determines whether new lines will be sent to the printer as: (A) CR/LF (a
carriage return followed by a line feed) or as (B) LF/CR. The default is (A).