Filter
Top Products
Port Configuration
86
NXA-ENET24 - Software Management Guide
Displaying Connection Status - CLI
This example shows the connection status for Port 13.
Field Attributes (CLI - Cont.)
• Capabilities: Specifies the capabilities to be advertised for a port during auto-negotiation. To
access this item on the web, see Configuring Interface Connections section on
page 87.
The following capabilities are supported.
• 10half - Supports 10 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 1000full - Supports 1000 Mbps full-duplex operation
• Sym - Transmits and receives pause frames for flow control
• FC - Supports flow control
• Broadcast storm: Shows if broadcast storm control is enabled or disabled.
• Broadcast storm limit: Shows the broadcast storm threshold. (500 - 262143 packets per second)
• Flow control: Shows if flow control is enabled or disabled.
•LACP: Shows if LACP is enabled or disabled.
• Port Security: Shows if port security is enabled or disabled.
• Max MAC count: Shows the maximum number of MAC address that can be learned by a port. (0 -
1024 addresses)
• Port security action: Shows the response to take when a security violation is detected. (shutdown, trap,
trap-and-shutdown)
Current status:
• Link Status: Indicates if the link is up or down.
• Operation speed-
duplex:
Shows the current speed and duplex mode.
• Flow control type: Indicates the type of flow control currently in use (IEEE 802.3x, Back-Pressure or
none)
FIG. 85
CLI - Displaying Port/Trunk Information