Filter
Top Products
Basic Configuration
29
NXA-ENET24 - Software Management Guide
Command Attributes
Manual Configuration - Web
Click System, IP. Specify the management interface, IP address and default gateway, then click Apply.
Manual Configuration - CLI
Specify the management interface, IP address and default gateway:
Command Attributes
• Management VLAN: This is the only VLAN through which you can gain management access to the
switch.
By default, all ports on the switch are members of VLAN 1, so a management station
can be connected to any port on the switch. However, if other VLANs are configured
and you change the Management VLAN, you may lose management access to the
switch. In this case, you should reconnect the management station to a port that is a
member of the Management VLAN.
• IP Address Mode: Specifies whether IP functionality is enabled via manual configuration (Static),
Dynamic Host Configuration Protocol (DHCP), or Boot Protocol (BOOTP).
If DHCP/BOOTP is enabled, IP will not function until a reply has been received from
the server. Requests will be broadcast periodically by the switch for an IP address.
(DHCP/BOOTP values can include the IP address, subnet mask, and default gate-
way.)
• IP Address: Address of the VLAN interface that is allowed management access.
Valid IP addresses consist of four numbers, 0 to 255, separated by periods.
• Subnet Mask: This mask identifies the host address bits used for routing to specific subnets.
• Gateway IP Address: IP address of the gateway router between this device and management stations that
exist on other network segments.
• MAC Address: The MAC address of this switch.
• Restart DHCP: Releases the current IP address and requests a new IP address from the DHCP
server.
FIG. 9
Web - Manual Web IP Configuration
FIG. 10 CLI - Manual Web IP Configuration