Filter
Top Products
Basic Configuration
34
NXA-ENET24 - Software Management Guide
Downloading Configuration Settings from a Server - Web
You can download the configuration file under a new file name and then set it as the startup file, or you can
specify the current startup configuration file as the destination file to directly replace it. Note that the file
“Factory_Default_Config.cfg” can be copied to the TFTP server, but cannot be used as the destination on the
switch.
Click System, File, Copy. Select “tftp to startup-config” or “tftp to file” and enter the IP address of the TFTP
server.
Specify the name of the file to download and select a file on the switch to overwrite or specify a new file name,
then click Apply.
If you download to a new file name using “tftp to startup-config” or “tftp to file”, the file is automatically set
as the start-up configuration file. To use the new settings, reboot the system via the System/Reset menu.
Note that you can also select any configuration file as the start-up configuration by using the System/File/Set
Start-Up page.
Downloading Configuration Settings from a Server - CLI
Enter the IP address of the TFTP server, specify the source file on the server, set the startup file name on the
switch, and then restart the switch (FIG. 20).
To select another configuration file as the start-up configuration, use the boot system command and then
restart the switch (FIG. 21).
FIG. 18 Copy Configuration Settings
FIG. 19 Setting the Startup Configuration Settings
FIG. 20 CLI - Downloading Configuration Settings from a Server
FIG. 21 CLI - Boot System