Filter
Top Products
CLI (Command Line Interface)
164
NXA-ENET24 - Software Management Guide
Command Groups
The system commands can be broken down into the functional groups shown below.
Keystroke Commands (Cont.)
Keystroke Function
Ctrl-E Shifts cursor to end of command line.
Ctrl-F Shifts cursor to the right one character.
Ctrl-K Deletes all characters from the cursor to the end of the line.
Ctrl-L Repeats current command line on a new line.
Ctrl-P Enters the last command.
Ctrl-R Repeats current command line on a new line.
Ctrl-U Deletes from the cursor to the beginning of the line.
Ctrl-W Deletes the last word typed.
Esc-B Moves the cursor back one word.
Esc-D Deletes from the cursor to the end of the word.
Esc-F Moves the cursor forward one word.
Delete key or backspace key Erases a mistake when entering a command.
Command Group Index
Command Group Description Page #
•Line Sets communication parameters for the serial port and Telnet,
including baud rate and console time-out
165
• General Basic commands for entering privileged access mode, restarting
the system, or quitting the CLI
169
• System Management Controls system logs, system passwords, user name, browser
management options, and a variety of other system information
171
• Flash/File Manages code image or switch configuration files 193
• Power over Ethernet Configures power output for connect devices 196
• Authentication Configures RADIUS and TACACS+ client-server authentication for
logon access and commands for IEEE 802.1x port access control.
199
• Access Control Lists Provides filtering for IP frames (based on address, protocol, TCP/
UDP port number or TCP control code) or non-IP frames (based
on MAC address or Ethernet type)
209
•SNMP Activates authentication failure traps; configures community
access strings, and trap managers; also configures IP address fil-
tering
224
• Interface Configures the connection parameters for all Ethernet ports,
aggregated links, and VLANs
231
• Mirror Port Mirrors data to another port for analysis without affecting the data
passing through or the performance of the monitored port
237
• Rate Limiting Controls the maximum rate for traffic transmitted or received on a
port
238
• Link Aggregation Statically groups multiple ports into a single logical trunk; config-
ures Link Aggregation Control Protocol for port trunks
239
• Address Table Configures the address table for filtering specified addresses, dis-
plays current entries, clears the table, or sets the aging time
246
• Spanning Tree Configures Spanning Tree settings for the switch 248
•VLANs Configures VLAN settings, and defines port membership for VLAN
groups; also enables or configures private VLANs
255
• GVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
262